YG－WY H型電動互輪車智能充電器有電壓輸出，但充不進去電。

　　根據故障現象，初步判斷電源輸人整流電路部分有故障，有可能是輸出電源插頭與充電插座接觸不良所致。用十字旋具將充電器的4顆緊固螺釘拆下，打開上蓋。首先看到輸八整流電路申的咆源濾波電容C5（82 uF/400V）已炸裂、漏液。然后用萬用表：“R*1”擋測量輸出電源插頭和充電插座，發現阻值很小，幾乎為0Ω，這說明它們接觸良好。為了萬無一失，再用萬用表測量其他易損壞的元件及充電保險管，相關的電路圖如圖1 所示。經測量均未損壞。最后換上一個與原來的耐壓（耐壓可大于原來的值，但絕對不能小于原來的值）和容量相同的電解電容（82 n F／400∨），焊好，插上電源插頭和充電插頭，經數小時的充電，充龜器上的“充滿”指示燈亮，表明蓄電池已充滿，故障排除。